Filter
Top Products
www.fmiproducts.com
122280-01E 29
INSTALLATION
Continued
Figure 34 - Installing Fireplace Screen
Ring
Screen
Push
On Nut
Screen
Rod
Bracket
Smoke Shelf
Screen
Rod
Fireplace Front
CAUTION: Gloves should
1. Plug module into J-Box on the right side
of rebox oor.
2. Connect shutoff valve of module to exible
gas line.
3. Connect wires from limit switch to module
(see Wiring Diagram, page 35).
4. Carefully place module into hearth in
rebox. Attach using 3 screws each on
left and right of module. Be careful not to
chip or break logs.
Figure 32 - Installing Module into Firebox
Figure 33 - Installing Floor Media
Scrap
Logs
Ember
Material
Ember
Flakes
Lava Rock
INSTALLING FLOOR MEDIA
1. Ember akes should be placed upright
into grooves between ports on ember bed
(see Figure 33).
2. Place lava rock around base of burner on
hearth oor. Make sure burner ports are
not covered.
3. Gloves must be worn when working with
ember material. Pull ember material apart
into pieces no larger than a dime. Place
pieces loosely and sparingly directly over
holes of front burner (ember bed). This will
create a glowing ember appearance as
ame touches ember material. Do not block
pilot ports with embers. It is not necessary
to use all ember material provided.
4. Place scrap log pieces randomly as de-
sired on replace hearth oor around base
of log set.
5. Set andirons in place at sides of grate.
J-Box
Plug
Shutoff
Valve
INSTALLING SCREEN
Reinstall smoke shelf before installing screen.
See Removing and Installing Smoke Shelf
on page 18.
1. Mount screen rod brackets on left and
right side of rebox with #8 x 1/2" screws
provided (see Figure 34).
2. Slide round end of screen rod into rings at
top of screen. Attach one push-on nut to end
of rod before attaching last ring of screen.
3. Insert round end of rod into rod bracket
on left side of replace.
4. Mount at end of screen rod with #10 x 5/8"
to center of smoke shelf (see Figure 34).
5. Install other screen rod in same manner.
Andiron