Filter
Top Products
•
Load GWBASIC
•
Load and then run the program TC847.BAS
•
Set the Baud Rate on the Controller of the 9112A to 9600
•
Set the address of your furnace to 10 or greater
•
Set the temperature or if needed the furnace parameters. A listing of the
parameters and their meaning are in the following table.
To set a parameter, simply type in the parameter and the value. For example, to
set the control temperature to 800°C, type SL=800.
9112A Calibration Furnace
User’s Guide
26
PV process value (temperature)
SL set-point
OP output power
XP proportional band
TI integration time
TD derivative time
CH Cycle time
Table 2. Command Parameters