Filter
Top Products
3
IMPORTANT - PLEASE READ AND FOLLOW
✓ Before beginning, please read these instructions completely and
carefully.
✓ Do not remove permanently affixed labels, warnings, or plates
from the product. This may void the warranty.
✓ Please observe all local and national codes and ordinances.
✓ Please ensure that this product is properly grounded.
✓ The electrical plug should always be accessible.
✓ The installer should leave these instructions with the consumer
who should retain for local inspector's use and for future reference.
Installation must conform with local codes or in the absence of codes, the National Fuel Gas Code ANSIZ223.1
- Iatest edition. Electrical installation must be in accordance with the National Electrical Code, ANSI/NFPA70
- latest edition and/or local codes. IN CANADA: Installation must be in accordance with the current CAN/
CGA-B149.1 National Gas Installation Code or CAN/CGA-B149.2, Propane Installation Code and/or local
codes. Electrical installation must be in accordance with the current CSA C22.1 Canadian Electrical Codes
Part 1 and/or local codes.
INSTALLATION IN MANUFACTURED (MOBILE) HOME: The installation must conform with the Manufactured
Home Construction and Safety Standard, Title 24 CFR, Part 3280 [formerly the Federal Standard for Mobile
Home Construction and Safety, Title 24, HUD (Part 280)] or, when such standard is not applicable, the Standard
for Manufactured Home Installations, ANSI/NCSBCS A225.1, or with local codes where applicable.
INSTALLATION IN RECREATIONAL PARK TRAILERS: The installation must conform with state or other codes
or, in the absence of such codes, with the Standard for Recreational Park Trailers, ANSI A119.5.
Installation of any gas-fired equipment should be made by a Iicensed plumber. A manual shut-off valve must
be installed in an accessible location in the gas line external to the appliance for the purpose of turning on or
shutting off gas to the appliance (In Massachusetts such shutoff devices should be approved by the Board
of State Examiners of Plumbers & Gas Fitters).
If an external electrical source is utilized, the appliance, when installed, must be electrically grounded in accor-
dance with local codes or, in the absence of local codes, with the national Electrical Code, ANSI/NFPA 70.
This range is supplied with a protective film on steel and aluminium parts.
This film must be removed before installing/using the appliance.
FOR INSTALLER ONLY
THIS RANGE IS FOR RESIDENTIAL USE ONLY
DATA PLATE
CONVERSION LABEL