Filter
Top Products
16
b
After regulation repeat the operations indicated in paragraph “2. Pressure regulator” at
page 9 and 12.
If the range has been disconnected and then connected again to the gas supply line
repeat the operations indicated in paragraph “5. Leak Testing” at page 12.
IMPORTANT:
After conversion to LP/PROPANE gas has been carried out affix inside the drawer, near
the data plate, the conversion label supplied and also affix a conversion label at page
3 of this instruction manual.
ADJUSTMENT OF THE OVEN BURNER MINIMUM
This needs to be done only for the oven burner (the broil is a fixed capacity) by acting
on the thermostat in the following way:
– Turn on the burner by setting the thermostat knob on position
8.
– Remove the knob and unscrew the by-pass screw "G" (fig. 2.14) about three times
by passing a small flat screwdriver (Ø 3 mm blade, 100 mm length) through the panel
opening.
– Re-mount the knob and let the oven heat up for about 10 minutes, then bring the knob
to position
1 (minimum) to operate the thermostat by-pass.
– After having removed the knob again and being very careful not to turn the tap rod,
slowly screw the by-pass screws “G” (fig. 2.14) until you obtain a flame of 3-4 mm
in height.
N.B. For LP/PROPANE gas the by-pass screw must be fixed thoroughly.
G
Fig. 2.14
2