Fisher 9500 Plumbing Product User Manual


 
9500 Valve
Instruction Manual
Form 2433
November 2007
2
Table 1. Specifications
Valve Sizes
NPS J 2, J 3, J 4, J 6, J 8, J 10, or J 12
Valve Body Style
Flangeless (wafer-type) valve body to be installed
between pipeline flanges
End Connection Styles
Flangeless (wafer-style) valve body mates with
CL125 flat-face flanges per ASME B16.1, with
CL150 and 300 raised-face flanges per ASME
B16.34, or EN flanges
Maximum Allowable Inlet Pressure
(1)
Consistent with applicable pressure/temperature
ratings for JCL125B per ASME B16.1, or
JCL150 and 300 per ASME B16.34 unless
limited by maximum allowable pressure drop
specification or by material temperature
capabilities in table 2
Vacuum Service
The valve is suitable for vacuum service to
approximately 10
-7
mm Hg absolute
(3.4 x 10
-12
mbar, absolute)
Maximum Shutoff Pressure Drop
(1)
Standard Operation
Cast Iron Valve: 12.1 bar (175 psi)
Steel or Stainless Steel Valve: 15.2 bar (220 psi)
Material Temperature Capabilities
(1)
See table 2
Flow Characteristic
Conventional Disc: Approximately equal
percentage through 60 degrees of disc rotation
Fishtail Disc: Approximately equal percentage
through 90 degrees of disc rotation
Flow Direction
Conventional Disc: Bidirectional
Fishtail Disc: Forward flow – The tail of the disc
opens into the downstream end of the valve
(see figure 2).
Disc Rotation
Conventional Disc
On/Off Service: J 0 to 60 or J 0 to 90 degrees
Throttling Service: 0 to 60 degrees
Fishtail Disc: 0 to 60 or 0 to 90 degrees for on/off
or throttling
Shutoff Classification per ANSI/FCI 70-2 and IEC
60534-4
Nitrile Liner or PTFE Liner: Class VI
Mating Flange Capabilities
All sizes compatible with welding-neck flanges;
also see Installation section for slip-on flanges
Code Classifications
Dimensions meet MSS SP-67 specifications for
face-to-face dimensions for flangeless valves
Approximate Weights (Valve Body Assemblies
Only)
NPS 2: 9 kg (20 lb)
NPS 3: 11 kg (25 lb)
NPS 4: 14 kg (30 lb)
NPS 6: 20 kg (45 lb)
NPS 8: 27 kg (60 lb)
NPS 10: 32 kg (70 lb)
NPS 12: 54 kg (120 lb)
1. The pressure/temperature limits in this manual and any applicable standard or code limitation should not be exceeded.
Table 2. Operative Temperature
Disc
Type
Liner
Material
Operative
Temperature
Conventional or Fishtail
Nitrile
-7 to 93_C (20 to 200_F)
Conventional or Fishtail
PTFE
-18 to 121_C (0 to 250_F)
Installation
WARNING
Always wear protective gloves,
clothing, and eyewear when
performing any installation operations
to avoid personal injury.
Personal injury or equipment damage
caused by sudden release of pressure
may result if the valve assembly is
installed where service conditions
could exceed the limits given in table 1
or on the appropriate nameplates. To
avoid such injury or damage, provide a
relief valve for over-pressure
protection as required by government
or accepted industry codes and good
engineering practices.
Check with your process or safety
engineer for any additional measures