Filter
Top Products
– 18 –
86(5)81&7,216
Using Device Commands (Lights On/Lights Off Keys)
General Information
Your system may be set up so that certain lights or other devices can be turned on or off
by using the device command from the keypad. Ask your installer if this has been done in
your system. If programmed for your system, some devices may activate automatically
upon certain system conditions. In this case, the following commands can be used to
override the device activation. See your installer for a full explanation of this feature.
To activate devices 1-6: #
+ LIGHTS ON + device no. (2 beeps)
To deactivate devices 1-6:
# + LIGHTS OFF + device no. (2 beeps)
To activate devices 7 & 8**:
*
*
*
*
+ # + LIGHTS ON + device no.
Your security code (2 beeps)
To deactivate devices 7 & 8**:
* * * *
+ # + LIGHTS OFF + device no.
Your security code (2 beeps)
** Devices 7 and 8 may be assigned to system devices, such as alarm bells, which should
not be activated using this command, because they are activated automatically under
certain system conditions. See your installer and the table below.
Device Descriptions
See your installer for device numbers assigned for your system.
Device Description
1
2
3
4
5
6
7
8