FilterStream A600 Air Cleaner User Manual


  Open as PDF
of 24
 
Page 18 AirTamer®
Troubleshooting Guide
Issue Resolution
CHANGE
FILTER LIGHT
is orange.
This may mean that it is time to replace the AIR FILTER
installed in your unit. This is dependant upon which
model of air lter you are using.
OnceyoureplacetheAIR FILTER in your unit, press and
hold the CHANGE FILTER LIGHT BUTTON for three (3)
seconds. The lights on the unit will then ash once, and
the CHANGE FILTER LIGHT BUTTON will change back
to green and begin counting down another six (6)
month period of time.
CHANGE
FILTER LIGHT
is pulsing
orange.
This means that you have run the unit for two (2) weeks
after the CHANGE FILTER LIGHT has changed to
orange and you must replace the AIR FILTER soon (or
reset the CHANGE FILTER LIGHT if you are using a 12
month lter).
OnceyoureplacetheAIR FILTER in your unit, press and
hold the CHANGE FILTER LIGHT BUTTON for three (3)
seconds. The lights on the unit will then ash once, and
the CHANGE FILTER LIGHT BUTTON will change back
to green and begin counting down the life on your new
AIR FILTER.
TheLED
lights on the
AirTamer® are
too bright.
I want the
lights on the
unit to be o.
To turn the lights on the AirTamer® DOWN or OFF,
press and hold the POWER button while the unit is
on. The unit will then cycle through its 16 brightness
levels. When you have reached your desired level
of brightness, release the POWER button. The unit
will stay at that brightness level until you readjust it
following the same steps.
Note:
After pressing any button on the unit, the brightness
levelwillgotoHighandthenreturntoyourchosen
brightness level after four (4) seconds.
HW_A600_UserMan_ENG_09.indd 18 5/11/09 2:25:06 PM
 previous next