Filter
Top Products
Installing the Canopy Housing
1. Screw in two threaded rods into the Hanger Bracket
(Figure 1).
NOTE: The threaded rods in the hanger bracket serve as
guides for easier installation.
2. Securely attach the Canopy Housing to the Hanger
Bracket using the external lock washers and knurled knobs
supplied with your fan (Figure 2).
Figure 1
NOTE: Supply wires and
fan wires omitted for clarity.
NOTE: This step is applicable after the necessary wiring
is completed. (see page 9)
▲
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
Figure 2
10
Assembling and Mounting the Fan Blades
1. Lay blade holder with the threaded posts facing up.
2. Position the wood blade over the blade holder with the
threaded posts showing through the holes of the blade.
3. With a Phillips screwdriver, tighten washer-head screws
with fiber washers. (Figure 1)
4. Attach assembled blades and blade holders to the motor
hub using the provided screws. (Figure 2)
5. Make sure the screws securing the blade holders to the
motor hub are tight and that the blade holders are properly
seated.
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
▲
WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.
Figure 1
Figure 2