Excalibur electronic 9013 Home Safety Product User Manual


 
1716
Battery Information
Batteries should be installed and replaced
only by an adult.
Forever Flashlight 7-in-1 Survivor Tool uses
3 AAA batteries, not included.
Do not mix alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries.
Do not mix old and new batteries.
Do not use rechargeable batteries.
Remove exhausted batteries from the unit.
Do not short circuit battery terminals.
Remove batteries and store them in a cool,
dry place when not in use.
To avoid explosion or leakage, do not dispose
of the batteries in a fire or attempt to recharge
alkaline or other non-rechargeable batteries.
Install batteries so that the polarity (+ and -) matches the
diagrams in the battery compartment.
Use only batteries of the same type and equivalency.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable l interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful inter-
ference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TVtechnician for help.