Filter
Top Products
THREADING THE UPPER THREAD
THREADING THE UPPER THREAD
16
5. Then, down and around the check spring holder.
6. At the top of this movement, pass the thread from right
to the left through the slotted eye of the take-up lever
and then downwards again.
7. Pass the thread behind the flat, horizontal thread guide.
4. Thread the tension module by passing the thread
between the silver discs.
9. Pull the end of the thread through the needle from front
to rear, and pull out about 10 cm of thread.
Use the needle threader to thread the needle. (On the
next page.)
8. Guide the thread through the wire loop.
6
7
5
4
8
9