Filter
Top Products
The ideal place for your Aquaguard Classic is above the
kitchen sink.
Your Aquaguard Classic can be fitted on the wall through
key slots provided at the back.
INSTALLATION
Your Aquaguard Classic will be installed free of cost by
our experienced Service Representatives.
You will require a standard 220/230 V supply and a
5 Amp. point. This should be a three pin type and
properly earthed. One end of the water drawing pipe
should be connected to the Aquaguard Classic and the
other end of the pipe should be inserted into the
container. Aquaguard Classic-Pump Model can not only
be used to pump water from a storage container or vessel
for the normal usage but also can be used for pre-cooler
installation (along with water level controller).
DIFFERENT WAYS TO
INSTALL YOUR
AQUAGUARD CLASSIC-
PUMP MODEL
Note: Kindly ensure that the source (storage container) has enough water before
you switch on your Aquaguard Classic.
7