Filter
Top Products
24632-0-0508 Page 19
6
7
9
Use a jigsaw to cut the holes out of the wall and discard the
inner circle debris. The wall is now prepared for the installation
of the unit.
Locate the studs in the wall and use at least four (4) wood screws
to attach the wall mounting plate to the wall.
If installing onto drywall (not into a stud), anchors must be
used.
Drill a pilot hole inside of the traced circle so that a jigsaw can
be used to cut the holes out.
Pilot
Hole
8
Pivot and remove casing door. Remove two screws from the
back inside of the unit and detach the wall mounting plate from
outside back of the unit.
INTERIOR PREPARATION AND INSTALLATION OF THE BACK OF THE UNIT