Enviro FS Stove User Manual


 
IMPORTANT SAFETY DATA
Please read this entire manual before installation and use of this pellet fuel burning room heater. Failure to follow
these instructions could result in property damage, bodily injury or even death.
CAUTION: DO NOT CONNECT OT ANY AIR DISTRIBUTION DUCT OR SYSTEM;
DO NOT BURN GARBAGE OR FLAMABLE FLUIDS SUCH AS GASOLINE, NAPTHA OR ENGINE
OIL;
HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY.
CONTACT MAY CAUSE SKIN BURNS.
Contact local building officials about restrictions and installation inspection requirements in your area.
The stove’s exhaust system works with negative combustion chamber pressure and a slightly positive chimney
pressure, it is very important to ensure that the exhaust system be sealed and airtight.
The use of grates or other methods of supporting the fuel is not permitted.
This unit is designed to burn pelletized wood fuel only. Do not use any other type of fuel, this will void any
warranties stated in this manual.
THE USE OF CORDWOOD IS PROHIBITED BY LAW.
Do not burn with insufficient combustion air. A periodic check is recommended to ensure proper combustion air
is admitted to the combustion chamber. Setting the proper combustion air is achieved by adjusting the slide
damper located on the left side of the stove.
It is advisable to clean the exhaust vent bi-annually or every two tons of pellets.
The grounded electrical cord should be connected to a standard 115 volts, 60-hertz electrical outlet. Be careful
that the electrical cord is not trapped under the appliance and that it is clear of any hot surfaces or sharp edges.
This unit’s maximum power requirement is 520 watts (4.52 Amps).
Soot or creosote may accumulate when the stove is operated under incorrect conditions such as an extremely
rich burn (black tipped, lazy orange flames).
When installing the stove in a mobile home, it must be electrically grounded to the steel chassis of the home and
bolted to the floor. Make sure that the structural integrity of the home is maintained.
Be sure to maintain the structural integrity of home when passing a vent through walls, ceilings, or roofs.
The ash pan and viewing door must be locked securely for proper and safe operation of the pellet stove.
If you have any questions with regards to your stove or the above-mentioned information, please feel free to
contact your local dealer for further clarification and comments.
Since Sherwood Industries Ltd. has no control over the installation of your stove, we grant no warranty implied or
stated for the installation or maintenance of your stove, therefore, Sherwood Industries Ltd. assumes no
responsibility for any consequential damage.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
3