Filter
Top Products
INSTALLATION OF LOG SET and EMBERS
INSTALLING THE GLOWING EMBERS
A bag of Rock Wool embers is provided for use on the burner tray.
CAUTION: Use only the type of ember material supplied with this appliance. Due to the irregular size of the
ember material there may be more than required.
If over time, through cleaning and servicing, these embers require replacement, contact your nearest
ENVIROGAS dealer for replacement embers.
Remove the ember material from the plastic bag.
Cover the shaded areas in the diagram shown beside.
Totally fill these areas with glowing ember material
Do not pack down, leave embers loose.
CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE DOOR REMOVED
INSTALLING THE LOGSET
Carefully remove log from box. Check to ensure there is no damage. It is very important to install this log in its
proper position to insure safe, optimum operating conditions.
1. Open the front door.
2. Place each piece of the log set into
the firebox resting the pins in the
holes in the log supports.
3. Close the door and tighten securely.
Upon the first light up, watch for ignition to
all burner ports. If a long delay is noted:
a) First, wait for the appliance to cool
down
b) Open the front door of the appliance.
(See adjusting the venturi section to adjust air for proper flame).
8