Filter
Top Products
29
Secondary Installation
BRICK LINER REMOVAL:
There are two (2) different brick liner sets; the ceramic set that comes with the unit or the optional cast
iron set. The following instructions are for both sets.
WARNING: DO NOT INSTALL LINER IF UNIT IS HOT.
1. Remove glass door (see MAINTENANCE AND SERVICE - GLASS DOOR REMOVAL)
2. Carefully remove the log set if it was installed.
3. Ceramic brick liners: Remove the liners: sides, back, then top.
Cast iron brick liners: Remove the bafe by using a T-20 screwdriver to loosen off but not remove the
two (2) screws at the back of the bafe lifting up over the back screws then out. Remove the side
liners then the back.
4. Ceramic brick liners: If the bafe needs to be removed use a T-20 screwdriver to loosen off but not
remove the two (2) screws at the back of the bafe and remove the two (2) screws at the front of the
bafe. Slide the bafe up over the back screws then out.
LOG SET AND EMBER INSTALLATION:
The placement of the logs is not arbitrary. If they are positioned incorrectly, the ames can be “pinched”
and will not burn correctly. The burner and a few of the logs come with locator pins, notches, and ledges
which make alignment easier The andirons and grate must be installed for the logs to be placed properly.
Using the pictures provided, carefully set the logs in place (see gures 39 through 43).
NOTE: The logs are fragile and should be handled gently. When removing the logs from their
packaging be careful and check that there are 5 large logs (back, left/center, left, right, and
center) and 2 small pieces before discarding of the packaging. One log may be covered by
cardboard.
Maintenance: Once a year the logs should be removed and checked for deterioration or large amounts
of soot. A small amount on the bottom side of the logs is normal. Remove and replace the logs in the
same manner described in this section.
If new/more embers and rock wool is required, contact your nearest ENVIRO dealer.
Never operate the replace with the glass door removed.
Baffle
Back Brick Liner
Side Brick Liners
To install the liners follow steps 1 to
4 in reverse.
Important installation notes:
Ensuring the brick liners are ush
against the rebox walls.
When sliding the bafe into place
making sure to hook the back into
place on the two loosened screws.
To install the log set follow the
instruction in LOG SET AND EMBER
INSTALLATION.
Figure 38: Cast Iron Brick Liner Installation.