Filter
Top Products
Installation
INSTALLATION OF THE SURROUND PANEL - INSERT:
The trim set for your surround panel must be installed before installing the surround panel onto the unit,
if not already done.
1. Remove the backing off the magnets and stick them inside the trim pieces as shown in Figure 45.
Figure 48: Screw to hold
the trim against the
surround.
Figure 46: Corner brackets for trim.
Figure 47: Two pieces of
corner bracket.
2. Attach one side trim to the top trim,
using a corner bracket (see Figure
46) to secure pieces together. There
are two (2) main pieces to each
corner bracket (see Figure 47). When
installing the corner pieces into the
trim, the “B FACE” sides must face
each other and the screw heads are to
face out. With the bracket in place and
the top and a side trim snug together,
use a at head screwdriver to turn
the two (2) screws in the bracket to
tighten it into the trim.
3. Slide the two (2) attached trim pieces
onto the surround panel.
4. Attach the other side trim piece to the
top trim, using the same method used
in Step 1.
5. Place the second side of the trim
on the surround panel in the same
manner used on the rst side and
secure in the same manner.
6. On the side trims, there are holes 2”
(50 mm) from either end. Use a Phillips
screwdriver to place a #8 screw 1”
long in each hole and tighten (refer to
Figure 48). This will keep the trim tight
against the surround.
There are two (2) hooks on either side
of the inside of the panel. Line up the
openings on the hooks with the screws
on the outside of either shroud (see
Figure 49). Push the surround in and
push it down into place.
Magnetic Strips
Figure 45: Magnet placement on trim.
Surround Panel
Side
Trim
#8 screw
Surround
Panel
Figure 49: Installation of Panel.
36