Filter
Top Products
To install the burner:
1. Insert the mixing tube into the mixing
tube box (refer to Figure 8 or 9).
2. When the burner is resting in the
rebox ensure that the front edge of
the burner is lined up with the front
lip of the rebox (see Figure 10 or
11).
3. Re-install the log set or rock set
(see SECONDARY INSTALATION - LOG SET
INSTALLATION or SECONDARY INSTALATION -
ROCK SET INSTALLATION) and the door.
4. Check burner for proper operation.
Figure 11: Align Rock Set Burner With Firebox.
Bring front lip of burner
to front edge of firebox.
Maintenance And Service
11
Figure 10: Align Log Set Burner With Firebox.
Bring front lip of burner
to front edge of firebox.
FIREBOX BAFFLE REMOVAL:
The rebox bafe can be remove when cleaning the venting pipe.
1. Remove the glass door as shown in the MAINTENANCE AND SERVICE - GLASS DOOR REMOVAL.
2. Remove the two (2) Torx T-20 screws holding the front of the rebox bafe in place (refer to Figure
12). IMPORTANT: The bafe should be held in place when the screws are removed to prevent it from
falling, which could damage the rebox liner, log set, or rock set.
3. Carefully push the back of the bafe up while pulling the front down (see A’s in Figure 13) then pull
the bafe out of the rebox.
4. Re-install the rebox bafe and the door when done.
Figure 13: Firebox Bafe Removal.
A
A
B
Figure 12: Firebox Bafe Screws Removal.