Filter
Top Products
11
Routine Cleaning and Maintenance
DOOR GLASS CLEANING (Weekly)
Cleaning of the glass must only be done when stove is cold. Open the door by lifting the handle. The glass
can be cleaned by wiping down the outside and inside of the glass with a dry soft cloth.
If the glass has build up that can not be removed with only the cloth, clean the glass using paper towel
and a gas appliance glass cleaner, this may be purchased through most dealers. If a gas appliance glass
cleaner is not available, use a damp paper towel dipped in y ash to clean the glass. After the glass has
been cleaned use the dry soft cloth to wipe down the outside and inside of the glass.
ASH PAN AND DOOR GASKETS (Weekly)
After extended use the gasketing may come loose. To repair this, glue the gasketing on using high-
temperature fiberglass gasket glue available from your local dealer. This is important to maintain an
airtight assembly.
ASH BOX (Weekly)
IMPORTANT: The unit must be OFF while the ash pan is removed.
The ash box is located behind the lower door (see Figure 10). To remove the ash box, lift the latch on the
right, open the ash box door, and lift it out.
Dump the ashes into a metal container stored away from combustibles. Monitor the ash level every week.
Remember that different pellet fuels will have different ash contents. Ash content is a good indication
of fuel efficiency and quality. Refer to “SAFETY
WARNINGS AND RECOMMENDATIONS” for disposal
of ashes. Vacuum the inside of the ash pan
compartment inside the pedestal including the
hole at the top back of the compartment.
Insert the ash box fully and close ash box
door.
DO NOT PLACE UNBURNED OR RAW
PELLET FUEL IN ASH PAN.
EXHAUST PASSAGES (Biannually)
• Open the firebox door by lifting the handle.
• Remove the burn pot and burn pot liner;
clean both.
• Using a ” socket, remove the two (2) bolts
that hold the firebox liner in place. Vacuum
the firebox and firebox liner thoroughly.
• Open the ash box door; remove the ash box
and cleanout the cavity.
• Clean out the transition box to the
combustion blower (located behind the ash
box)
• Lubricate all screws with penetrating oil.
• Re-install the ash box, firebox liner, burn
pot, and burn pot liner
• Close the firebox and ash pan doors and
secure.
Ash Box
Burn Pot
Burn Pot
Liner
Firebox Liner
Figure 10: Maxx Exhaust Passages.