Filter
Top Products
9
too much air – Close slider (push in) slightly.
• If the flame is in the middle of these two characteristics with a bright
yellow/orange, active flame with no black tips then the air is set for
proper operation, refer to Figure 7.
The combustion exhaust blower is a variable speed blower controlled by
the heat output button. This blower will decrease the vacuum pressure
inside the stove, adjusting the air to fuel ratio.
SPECIAL NOTES:
Pellet quality is a major factor in how the Pellet stove will operate. If the
pellets have a high moisture content or ash content the fire will be less
efficient and has a higher possibility of the fire building up and creating
clinkers (hard ash build-up).
HEAT LEVEL and Fans will drop down to the LOW setting for 30 minutes. If the thermostat contacts close
within the 30 minutes, the HEAT LEVEL will return to the previous MANUAL setting. If the thermostat
contacts remain open, the stove automatically begins its shutdown routine. The stove will re-light when
the thermostat contacts close again.
TURNING YOUR PELLET STOVE OFF:
• MANUAL and HI / LOW mode: To turn the unit OFF, simply press the ON / OFF button. This will stop
the feed of pellets. The blowers will continue to operate and cool the stove down. When cool enough,
the stove will turn off.
• AUTO / OFF mode: To turn the unit OFF, turn the Thermostat down or Timer off.
DO NOT turn unit off during start-up or unplug unit while operating; this may lead
to smoke escaping from the stove.
SLIDER/DAMPER SET-UP:
THE SLIDER / DAMPER MUST BE SET AT TIME OF INSTALLATION. A Qualified Service Technician
or Installer must set the Slider Damper.
If the fire should happen to go out and the heat output indicator has been set on the lowest setting, the
Slider Damper should be pushed in slightly, decreasing the air in the firebox.
Exhaust Channel
Slider Damper
Exhaust Fan
Housing
Operating Instructions
Figure 6: Slider/Damper Plate in Unit.
If, after long periods of burning, the fire builds up
and overflows the burn pot or there is a build up of
clinkers, this would be a sign that the pellet quality
is poor, this requires more primary air, the slider
damper must be pulled out to compensate. Pulling
the slider damper out gives the fire more air.
The easiest way to make sure that an efficient flame
is achieved is to understand the characteristics of
the fire.
• A tall, lazy flame with dark orange tips requires
more air – Open slider (pull out) slightly.
Figure 7: Efficient Flame.
• A short, brisk
flame, like a
blowtorch, has