Filter
Top Products
Page | 51
REPLACING COMPONENTS
Control Board
The Control Board (Part # PU-CBEP) is a digital read-out board. This board offers a
wide variety of settings to operate the unit. The right side panel should be removed prior to
removing the control board (freestanding unit). The control board can be removed from the unit
by loosening the two outside screws and pulling the board back to the inside. A 6-amp “quick-
blow” fuse is used on this Control Board.
NOTE: The bottom three control buttons are preset at the factory and are not user adjustable.
See the “Daily Operation” section beginning on page 25 of the manual for more
instructions on Control Board settings.
Recommended Heat Ranges:
Low Burn: Heat Range setting: 1 Room Air Blower setting: 1
Medium Low: Heat Range setting: 2 – 3 Room Air Blower setting: *
Medium High: Heat Range setting: 4 – 8 Room Air Blower setting: *
High Burn: Heat Range setting: 9 Room Air Blower setting: 9
* NOTE: Blower Speed will automatically be adjusted to the desired Heat Range that you
select.