Filter
Top Products
Page 10 16937-4-0806
LOG PLACEMENT
Every burner is shipped with a protective cover. This cover must
be removed before log placement.
The positioning of the logs is critical to the safe and clean operation
of this heater. Sooting and other problems may result if the logs
are not properly and firmly positioned in the appliance.
PROPER INSTALLATION SEQUENCE:
1. Install the rear log behind the pilot assembly directly on the
pins on each side of the rear log shield.
2. Install the front log in front of the grate. The log is located into
a notch area in the front grate area.
Refer to Figure 8 for the following warning.
Warning: Failure to position the parts in accordance with this
diagram or failure to use only parts specifically approved with
this appliance may result in property damage or personal
injury.
During initial operation of the new heater, burning logs will
give off a paper burning smell and orange flames will be
present. Simply open the windows for a few hours to vent the
odor.
Figure 8
PLACEMENT OF GLOWING EMBERS (rock wool)
Provided with the log set is a small bag of glowing embers (rock
wool) to be placed between logs on the flat metal surface of the
burner.
Placement of the glowing embers (rock wool) is very individual
and light coverage of the areas indicated will provide your best
effects. We recommend separation of the rock wool by hand and
make your coverage as light and fluffy as possible.
Place just enough rock wool on the burner to obtain the glow and
a gold, yellow flame.
Do not place rock wool over large ports in rear portion of
burner.
Rock wool should not be placed in the area of the pilot assem
-
bly.
Replacement of loose material (glowing embers) must be
purchased from Empire Comfort Systems, Inc. Application of
excess loose material (glowing embers) may adversely affect
performance of the heater. WARNING: All previously applied
loose material must be removed prior to reapplication.
Refer to Parts List, Page 22 to order loose material (rock wool).