Filter
Top Products
37
press PROGRAM
RUN
to resume
your normal program.
Large Lighted Liquid CrystalLarge Lighted Liquid Crystal
Large Lighted Liquid CrystalLarge Lighted Liquid Crystal
Large Lighted Liquid Crystal
Display (LCD).Display (LCD).
Display (LCD).Display (LCD).
Display (LCD).
The large numbers and letters on
your LCD screen make it easy to
see. In low light conditions, press
the button on top of the thermostat
and the display will light up for
three seconds. For ten minutes after
pressing the light button, pressing
any other button will light the
display for ten seconds.
The thermostat display alternately
shows the current time and the
current temperature on the left side.
The display also shows the
temperature you have programmed
or set on the right side of your
screen.
Arm Chair Programming.Arm Chair Programming.
Arm Chair Programming.Arm Chair Programming.
Arm Chair Programming.
The thermostat uses 24 VAC power
supplied by the system for normal
operation. The electrolytic capacitor
allows you the added convenience of
programming the thermostat even
when not attached to the wallplate,
Attach the thermostat to the
wallplate and allow the capacitor to
charge for at least one hour. After
the capacitor is charged you will
have approximately one hour after
removing the thermostat from the
wallplate to configure and program
the thermostat.
Thermostat Startup After TotalThermostat Startup After Total
Thermostat Startup After TotalThermostat Startup After Total
Thermostat Startup After Total
Power Loss.Power Loss.
Power Loss.Power Loss.
Power Loss.
On installation, or when power is
restored after a total power loss to
the thermostat, your thermostat will
automatically maintain a heating
temperature of 62°F (16°C) and a
cooling temperature of 85°F (29°C).
If the 24 volts from the Heating/
Cooling transformer is lost, your
thermostat will lose its display in 2
minutes and may lose time in about
5 hours. This hold up time will be
much shorter if the control had not
been powered for at least 4 hours
prior to the power outage. When
power is restored, the thermostat
will return to the temperatures listed
above.
If this happens, set the clock and
day of the week (use PROGRAM-
MING steps 1 through 6 from
“Entering Your Program” page
26), then select
HEAT, EMER,HEAT, EMER,
HEAT, EMER,HEAT, EMER,
HEAT, EMER,
COOLCOOL
COOLCOOL
COOL or
AUTOAUTO
AUTOAUTO
AUTO using the
SYSTEM
key, and press PROGRAM
RUN
to resume operation with your
Features