Filter
Top Products
Maintenance
LUBRICATION - All bearings are
permanently lubricated and do not require
further lubrication.
CLEANING - This fan may be wiped off
with a damp cloth. Do not allow the motor
to get wet. Do not use solvents or harsh
detergents.
7
Check to see that all connections are
tight, including ground, and that no bare
wire is visible at the wire connectors,
except for the ground wire.
CAUTION:Do not operate fan until blades
are in place. Noise and fan damage could
result.
WARNING
To avoid possible fire or shock, make
sure that the electrical wires are
completely inside the outlet box and not
pinched between the ceiling cover and
the ceiling.
WARNING
3. Slide the upper canopy up the rod
within 1/4" of the ceiling or beam and
securely tighten the setscrew.
4. If a remote speed control is to be used
refer to the instructions included with
that control for proper installation and
wiring.
5. Restore power.
6. After completing installation, test run
fan in normal operation manner.
Inspect for any possible shake or
wobble which may be caused by
binding as a result of "tight cable". if this
should happen, shut off power supply
and re-check instructions to correct
problem.
NOTE: When any solid state motor
speed control is used, a humming
noise may be present in the fan on low
speed. This hum in no way affects the
operation of the fan and is acceptable
in most industrial installations.
To avoid possible electrical shock, be
sure electricity is turned off at the main
service box before servicing.
WARNING
Do not use water when cleaning your
ceiling fan. It could damage the motor or
the blades and create the possibility of an
electrical shock.
WARNING
The use of any other control not
specifically approved for this fan could
result in fire, shock and personal injury.
WARNING
This product is designed to use only
those parts supplied with this product
and/or any accessories designated
specifically for use with this product by
Emerson Electric Co. Substitution of
parts or accessories not designated for
use with this product by Emerson Electric
Co. could result in personal injury or
property damage.
WARNING
Accessories
1. Downrod Extension Kits (see store or
catalog).
2. Ceiling Fan/Light Controls (see store or
catalog).
3. Suitable for use with Emerson Solid-
State Speed Control.
U.L. Model No.: HF948, HF956
BP7311 48 56" Heat Fans 1/16/08 10:52 AM Page 7