Filter
Top Products
IMPORTANT
Fan installation and programming of the
electronic controls must be completed, including
the installation of the fan blades, before testing of
the remote control.
Your remote control has full control of your fan and
lights.
1. To set the desired fan speed, press the 1, 2, 3, 4,
5, or 6 buttons to operate your fan on low to
highest speed (See Figure 16).
2. To turn your fan off, press the button.
3. To change the airflow direction of the fan blades,
press the button. The direction the fan blades
turn will change each time the button is
pressed. Allow 15 seconds for the fan to reverse
direction.
4. To turn the light ON or OFF, press and release the
button. The light will turn ON at the light level
previously set (See Step 5).
5. To set the level of light brightness, press and hold
the button. The light brightness will continue to
increase then decrease while the button is held
down. When the light is at the desired brightness,
release the button.
Red light turns on when any button is pressed.
If the light does not come on, replace the battery.
Replacement batteries for transmitter:
12V batteries recommended are Duracell MN21,
Eveready A23, and GP23A.
Operation of Your
Remote Control
FAN SPEED BUTTONS
AIR FLOW
DIRECTION BUTTON
LIGHT LEVEL
BUTTON
OFF BUTTON
3 4
1 6
2 5
Figure 16
8
Programming the Ceiling Fan
Receiver
1. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box.
2. Flip the wall switch to the ON position to supply
electricity to the outlet box circuit.
3. Press and hold the “SET” button on the back of the
transmitter for five seconds. The fan lights will turn
on or flash to indicate the programming procedure
has been successfully completed (Figure 15).
4. If the fan does not respond, select a new code
switch setting and repeat steps 4 - 5.
5. Programming is now complete, re-install the cover
onto the back of the transmitter.
NOTE: The ceiling fan receiver will not respond to
transmitter commands if the transmitter’s
frequency switch settings are changed without
reprogramming the receiver. Program the
receiver to the new frequency by repeating Steps
1 - 5 of “Programming the Ceiling Fan Receiver”
section.
U.L. Model No.: CF955
BATTERY COVER
REMOTE CONTROL
TRANSMITTER
"SET" BUTTON
SET
1
2
3
4
O
N
Figure 15