Filter
Top Products
1. Remove the fan motor and housing assembly from
the styrofoam packaging and position it so that the
top of the motor is facing you.
2. Remove the hanger ball from the downrod by
loosening the setscrew in the hanger ball until the
ball falls freely down the downrod (Figure 1).
Remove the pin from the downrod, then remove
the hanger ball. Retain the pin and hanger ball for
reinstallation in step 8.
3. Separate, untwist and unkink the three motor leads.
Route the motor leads through the downrod and
seat the downrod in the motor coupling (Figure 2).
4. Align the clevis pin holes in the downrod with the
holes in the motor coupling. Install the clevis pin
and secure with the hairpin clip (Figure 2). (Pin and
clip are supplied in loose parts bag.) The clevis pin
must go through the holes in the motor coupling
and the holes in the downrod. Push the straight leg
of the hairpin clip through the hole near the end of
the clevis pin until the curved portion of the hairpin
clip snaps around the clevis pin. The hairpin clip
must be properly installed to prevent the clevis pin
from working loose. Pull the hanger ball to make
sure the clevis pin is properly installed.
5. Install the setscrew (supplied) in the motor coupling
(Figure 2). While pulling up on the downrod, tighten
the setscrew using the setscrew wrench (supplied).
NOTE: The setscrews must be properly installed
as described above, or fan wobble could result.
6. Screw two 1” threaded studs (supplied) into the
motor (Figure 3). Leave approximately 7/8” of the
stud extending above the motor. Coil the wires and
wire connectors around the motor coupling then
slide the motor cover over the downrod and rotate
the cover until the threaded studs protrude. Install
two lockwashers(supplied) to secure the cover to
the motor. All wires and wire connectors must be
enclosed under the motor cover.
NOTE: Lightly snug the knurled knob and make
sure the wires and wire connectors are
completely inside the motor coupling cover and
not pinched between the motor coupling cover
and the motor.
7. Position the ceiling cover over the downrod. Be
sure the cover is oriented correctly, with the large
opening at the top (Figure 4).
4
How to Put Your Ceiling Fan Together
PIN
HANGER
BALL
SETSCREW
DOWNROD
Figure 1
MOTOR
COVER
1" THREADED
STUD (2)
MOTOR
COUPLING
KNURLED
KNOB (2)
LOCKWASHER (2)
Figure 3
DOWNROD
MOTOR
COUPLING
HAIRPIN
CLIP
SETSCREW
CLEVIS
PIN
MOTOR
LEADS
SETSCREW
CLEVIS PIN
MOTOR
COUPLING
DOWNROD
HAIRPIN
CLIP
Figure 2
DOWNROD
CEILING
COVER
PIN
HANGER BALL
Figure 4
It is critical that the clevis pin in the motor coupling
is properly installed and the setscrews securely
tightened. Failure to verify that the pin and setscrews
are properly installed (as shown in Figure 2) could
result in the fan falling.
WARNING
!