Filter
Top Products
Turning off wall switch is not sufficient.
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse box before wiring. All wiring must be
in accordance with National and Local
codes and the ceiling fan must be
properly grounded as a precaution
against possible electrical shock.
!
WARNING
To reduce the risk of fire, electric shock,
or personal injury, mount fan to outlet box
marked “Acceptable for Fan Support”,
and use screws supplied with outlet box.
Most outlet boxes commonly used for
support of light fixtures are not
acceptable for fan support and may need
to be replaced. Consult a qualified
electrician if in doubt.
!
WARNING
Hanger bracket must seat firmly against
outlet box. If the outlet box is recessed,
remove wall board until bracket contacts
box. If bracket and/or outlet box are not
securely attached, the fan could wobble
or fall.
!
WARNING
SECURELY
TIGHTEN
SCREWS
HANGER
BRACKET
HOOK
Figure 13
NOTE: The hanger bracket must be
mounted flush with the ceiling in order
for the ceiling cover to install properly.
If necessary, use leveling washers (not
supplied) between the outlet box and
the hanger bracket.
2. Slide the hanger bracket onto the outlet
box screws. Center the bracket over
the outlet box and then securely tighten
the screws (Figure 13).
9
UL Model No.: CF130
2. Carefully lift the fan assembly up to the
hanger bracket. Pass the hook on the
hanger bracket through one of the
screw holes (not the slots) in the ceiling
cover (Figure 14). The hook must pass
from the inside of the ceiling cover to
the outside. The hook will hold the fan
assembly while connecting the wiring.
How to Hang Your
Ceiling Fan For Close-
to-the-Ceiling Mounting
The hook must pass through the screw
hole in the ceiling cover from the inside to
the outside. Any other hanging method
may cause the hook to break and the fan
to fall.
!
WARNING
DECORATIVE
UPPER COVER (2)
CEILING COVER
HOOK
HOOK ON HANGER BRACKET MUST PASS THROUGH
SCREW HOLE IN CEILING COVER, INSIDE OF
BRACKET TO OUTSIDE OF BRACKET
M5 x 10mm
SCREW AND
LOCKWASHER
(2 each)
FAN
HOUSING
Figure 14
1. For close-to-the-ceiling mounting, the
two decorative upper covers must be
removed before installation to hanger
bracket (Figure 14).
3. Loosely install two M5 x 10mm screws
and lockwashers (supplied) in hanger
bracket at this time. The remaining two
lockwashers and screws will be
installed after the ceiling fan is hung
(Figure 14).
BP7404 Tilo 12/16/09 4:06 PM Page 9