Filter
Top Products
1. Position the hanger bracket on the
outlet box so that the T-slots in the
hanger bracket are aligned with the
outlet box screws (Figure 12).
Installation of
Hanger Bracket
The fan must be hung with at least 7' of
clearance from floor to blades (Figure 11).
!
WARNING
The outlet box and joist must be securely
mounted and capable of supporting at
least 50 lbs. Use only a U.L. outlet box
listed as “Acceptable for Fan Support”.
!
WARNING
CEILING
FLOOR
AT
LEAST
7'
Figure 11
SLIDE THE HANGER
BRACKET ONTO
THE OUTLET BOX
SCREWS, THROUGH
THE T-SLOT
OUTLET
BOX
HANGER
BRACKET
T-SLOT
LOOSEN TWO
SCREWS (SUPPLIED
WITH OUTLET BOX)
Figure 12
8
UL Model No.: CF130
1. Remove and retain three screws from
the top of the motor housing (Figure 9).
2. Position the rubber gasket (supplied in
parts bag) on the motor housing (small
holes in gasket cenered over the screw
holes in the housing) Figure 9.
3. Position the ceiling cover onto the top
of the motor housing and reattach the
three screws previously removed
(Figure 10).
Installing the Ceiling
Cover on the
Fan Motor Housing
(For Close-to-the-Ceiling Mounting)
REMOVE AND RETAIN
3 SCREWS
(every other one)
RUBBER
GASKET
MOTOR
HOUSING
Figure 9
CEILING
COVER
SCREW (3)
RUBBER
GASKET
Figure 10
NOTE: The decorative lower cover,
coupler cover and hanger ball assembly
are not needed for close-to-the-ceiling
mounting.
NOTE: The four hanger bracket screws
and lockwashers are included in the
parts bag for this fan. Must be installed
for Dual-Mount and NOT used with
Downrod (standard) Mount.
BP7404 Tilo 12/16/09 4:06 PM Page 8