Filter
Top Products
7
UL Model No.: CF130
HAIRPIN
CLIP
CLEVIS PIN
MOTOR
COUPLING
COUPLER
COVER
GROMMET
DOWNROD
SETSCREW (2)
Figure 6
4. While pulling up on the downrod,
securely tighten the two setscrews in
the motor coupling (Figure 6).
NOTE: The setscrews must be properly
installed as described above, or fan
wobble could result.
5. Make sure the grommet is properly
installed in the coupling cover then
slide the coupler cover on the downrod
until it rests on the motor housing
(Figure 6).
SETSCREW
CEILING
COVER
PIN
DOWNROD
HANGER
BALL
DECORATIVE
UPPER COVER
DECORATIVE
LOWER COVER
CEILING
COVER
Figure 8
Figure 7
It is critical that the pin in the hanger ball
is properly installed and the setscrew
securely tightened. Failure to verify that
the pin and setscrew are properly
installed could result in the fan falling.
!
WARNING
7. Reinstall the hanger ball (Figure 8) on
the downrod as follows. Route the
motor leads through the downrod.
Position the pin through the two holes
in the downrod and align the ball so the
pin is captured in the groove in the top
of the hanger ball. Pull the hanger ball
up tight against the pin and securely
tighten the setscrew in the hanger ball.
A loose setscrew could create fan
wobble.
6. Place the decorative lower cover and
ceiling cover over the downrod. Be sure
both pieces are oriented correctly
(Figure 7).
8. The fan comes with blue, black and
white leads that are 42” long. Before
installing fan, measure up approx-
imately 6 to 9-inches above top of
hanger ball/downrod assembly. Cut off
excess leads and strip back insulation
1/2-inch from end of leads.
BP7404 Tilo 12/16/09 4:06 PM Page 7