The Plasmacluster ion generator inside the air conditioner
will release positive and negative Plasmacluster ions into
the room. Approximately the same numbers of positive
and negative ions released into the air will reduce some
airborne mould, allergens and viruses.
1. Press the PLASMACLUSTER button during operation.
• The remote control will display “ ”.
• The blue PLASMACLUSTER lamp on the unit will
illuminate.
To cancel
Press the PLASMACLUSTER button again.
• The PLASMACLUSTER lamp on the unit will turn off.
NOTES:
• Use of the PLASMACLUSTER function will be memorised
and it will be activated the next time you turn on the air
conditioner.
• To turn off the PLASMACLUSTER lamp, press the
DISPLAY button.
• PLASMACLUSTER operation cannot be set during
VENTILATION mode.
Plasmacluster operation
�
�
Use this mode when the remote control is not available
1. Press the MANUAL button on the unit.
• The red OPERATION lamp on the unit will illuminate.
• If the unit has not been unplugged since its last
operation it will resume operation at its last settings.
• If the unit has been unplugged since its last operation,
it resumes operation in the cooling mode, set at 0°C
with the fan speed set to AUTO.
To turn off
Press the MANUAL button again.
• The red OPERATION lamp on the unit will turn off.
NOTES:
• If the MANUAL button is pressed during normal operation, the
unit will turn off.
• Upon starting MANUAL operation, the drainage pump inside the
unit runs for about a minute, which may produce an audible
gurgling sound.
Manual operation
�
�
18 plasmacluster/manual operation electrolux EXP09CS1WI