Filter
Top Products
Control Panel
Best results are obtained by using a low speed
for normal conditions and a high speed when
odours are more concentrated.
Turn the hood on a few minutes before you start
cooking, you will then get an under pressure in
the kitchen. The hood should be left on after
cooking for about 15 minutes or until all the
odours have disappeared. The control switches
are located on the units front panel:
the light switch switches the hood lamp ON
and OFF;
ON/OFF Extractor fan switch - Push button
1: used to turn the fan off and to set the fan to
speed 1.
Push button 2: used to set the fan to speed 2.
Push button 3: used to set the fan to speed 3.
Correct ventilation
If the cooker hood is to work correctly there must
be an under pressure in the kitchen. It is important
to keep the kitchen windows closed and have a
window in an adjacent room open.
Light switch
ON/OFF
Extractor fan
switch -
Push button 1
Push button
2
Push button
3
Fig. 3 - Control Panel
Recirculation Version
The air is filtered through a charcoal filter and
returned to the kitchen through the side grids.
You will need an original Electrolux charcoal
filter for this function (Available from your
local Electrolux Service Force Centre).
Fix the deflector using 2 screws Ø 3,5x6.5 mm.
Fix the connection flange using 2 screws Ø
3,5x6.5 mm.
Charcoal
filter
Screw
Screw
Grease
filters
Side grids
Deflector
Connection
flange
Chimney
support
Fig. 2 - Control Panel