Drolet SIT 0.820.633 Stove User Manual


 
ULTRA FLAME DIRECT VENT GAS STOVE 16
Gas Piping
Move the ULTRA FLAME to the desired position.
Mark the location for the gas inlet pipe and the
location where the vent pipes will go through the
wall. Remove the appliance.
Route a 3/8" minimum NPT iron pipe gas line to the
desired location.
Install a shutoff valve to the gas line. Tighten
securely using a pipe joint compound.
Check the gas line piping for leaks. Use a soap and
water solution.
CAUTION: Do not use open flame to check leaks.
Electrical Connections
If you wish to make a direct electrical connection to the blower without using the six-foot cord supplied, route a
120 volt, 60 Hz electrical power supply line to the same location. Remove the power cord and connect the
120V line as per the following procedure:
Unscrew the speed control unit and pull a few inches away from the junction box
Unscrew the two marr connectors attached to the cord (P) and the cord ground
Remove the cord and route the supply line through the same holes
Make the electrical connection with the same wires the cord was attached to
Screw the ground wire to the junction box (G)
Screw the speed control unit back in place
P
P
G
CONNECT THE POWER LINE TO THE SAME
WIRES THE CORD WAS CONNECTED TO (P)
SPEED CONTROL
JUNCTION BOX
If you prefer to use the six-foot cord supplied, just connect it to a 120V outlet.