Dimplex HFPI9280 Indoor Fireplace User Manual


 
2
HFPI9280, DFI2311
Auto Mode
Note
When auto mode is activated the flame and heat will turn on. The heater will turn on
and off to keep the room temperature the same as the remote controls set temperature.
1. Use the UP and DOWN buttons to set the desired target temperature.
2. Press the AUTO/OFF button once to activate the auto mode. In auto mode the
remote transmitter will automatically turn on the flame and heater when the room
temperature is below the target temperature and turn off the heater ONLY when the
room temperature is above the target temperature.
3. Press the AUTO/OFF button to turn off the heater and flame (if it is already on) and
exit the auto mode.
Sleep Mode
1. You can set the timer to the length of time you want the heater to operate
(1 to 120 minutes).
2. Press the TIMER button once. The timer display will blink ---
3. Press the UP and DOWN buttons to adjust the timer display in minutes.
4. Press the TIMER button once to set the timer.
5. The timer setting can be reset by pressing the TIMER button and using the DOWN
button until the timer display reads ----, press the TIMER button once to set the
timer.
6. Press the AUTO/OFF button to turn on the heater.
7. The heater will turn off at the end of the timer setting.
Child Proof Function
1. Remove the battery cover on the back of the remote control.
2. Slide the small blue switch down to activate the child proof function.
3. Child Proof will appear on the display screen and all function on the remote will be
locked.
4. To enable normal remote control operation when the child proof function is activated,
press the up and down buttons in the following sequence,
UP-DOWN-DOWN-UP-DOWN the remote functions will now operate normally. The
remote will return to the child proof function if buttons are not pressed after two
minutes.
5. To disable the child proof function remove the battery cover on the back of the
remote and slide the small blue switch up.
Batteries
1. The remote control uses 3 AAA size batteries. Replace these batteries at least
every 6 months or when the low battery appears on the remote display screen.
2. When batteries are removed wait at least 1 minute before replacing with new
batteries.