Filter
Top Products
1
HFPI9280, DFI2311
OPERATION
Initializing The Remote Control
1. Turn on the electrical power at the circuit breaker.
2. Slide open the battery cover on the back of the remote transmitter.
3. Install three AAA batteries into the remote control. Replace the battery cover.
Note:
The LCD display will flash when new batteries are inserted.
4. Move the remote transmitter close to the fireplace (less than five feet preferred).
Press any button on the remote control. The remote is transferring the code to the
receiver built into the fireplace.
5. Set the clock by depressing the button marked clock on the transmitter for five
seconds. The hour display will flash.
6. Use the up and down buttons to set the hour.
7. Press the clock button again and the minute display will flash.
8. Use the up and down buttons to set the minute.
9. Press the clock button again and the
0
F or
0
C display will flash.
10. Use the up and down buttons to select the remote to display temperature in
0
F or
0
C
11. Press the clock button again. The remote control is now ready for operation.
Remote Control Operation
Warning
It takes some time for the receiver to respond to the transmitter. Do not press the
buttons more than once within two seconds for correct operation.
Flame Mode
Note
When flame mode is activated the flame will turn on only.
Note
When the flame button is pressed the display screen will display the flame status on or
off.
To turn the flame on:
1. Press the FLAME button once.
2. The display screen will read OFF.
3. Press the FLAME button turn the flame on.
To turn the flame off:
1. Press the FLAME button once.
2. The display screen will read ON.
3. Press the FLAME button to turn the flame OFF.