7
Site Selection and Preparation
!
NOTE 1:
circuit is required. A dedicated
circuit is preferred but not
essential in all cases. A
dedicated circuit will be
required if, after installation,
the circuit breaker trips or fuse
blows on a regular basis when
the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
WARNING: Ensure the power
cord is not installed so that it
is pinched or against a sharp
edge and ensure that the
power cord is stored or
secured to avoid tripping or
snagging to reduce the risk
to persons.
Construction and electrical
outlet wiring must comply with
local building codes and other
applicable regulations to
shock and injury to persons.
Do not attempt to wire your
own new outlets or circuits. To
shock or injury to persons,
always use a licensed
electrician.
This section provides instructions
for selecting a location and
preparing the site to install the
surround.
① Select a suitable location that
is not susceptible to moisture and
is away from drapes, furniture and
② For ease of electrical hook
up you may wish to locate the
(refer to NOTE 1).
③
dry and dust free location.
!
NOTE: The dimensions of
does not require any additional
venting.