Filter
Top Products
108117
For more information, visit www.desatech.com
For more information, visit www.desatech.com
23
23
INSTALLATION
Installing Logs (EFP33PR/EFP33NR)
INSTALLATION
Continued
INSTALLING LOGS (EFP33PR/EFP33NR)
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place the base of the middle log (#1) in the U-shaped slots of
the grate base. The cutout on the right of the middle log should
fit over the burner (see Figure 49). Make sure the front of the
middle log is resting on the tabs of the grate base and the cut-
out area is centered over the burner “U” bend.
2. Locate pegs on the bottom of back log (#2). Slide these pegs into
the holes in the grate base behind the burner (see Figure 50).
3. Locate the notches in the bottom of the front log (#3). Place
the front log on the grate fingers. Make sure the notches of the
front log line up with the grate fingers (see Figure 51).
4. Place crossover log (#4) onto the peg (right) on back log (#2)
and into the recess of the middle log (#1) (see Figure 52).
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
CAUTION: Do not remove the warning and in-
struction labels attached to the heater base assem-
bly. These markings contain important warranty
information.
CAUTION: After installation and periodically there-
after, check to ensure that no flame comes in contact
with any log. With the heater set to HIGH, check to see
if flames contact any log. If so, reposition logs ac-
cording to the log installation instructions in this
manual. Flames contacting logs will create soot.
Figure 52 - Installing
Crossover Log (#4)
Figure 50 - Installing Back
Log (#2)
Figure 51 - Installing Front
Log (#3)
Figure 49 - Installing Middle
Log (#1)
Middle
Log (#1)
"U"-
shaped
Cutout
in Base
Burner
Back Log (#2)
Peg
Peg
Grate
Fingers
Notches
Front
Log (#3)
Crossover
Log (#4)
Peg
Recess