Filter
Top Products
www.desatech.com
119305-01A
11
INSTALLATION
Continued
Mantel Clearances for Built-In
Installation
If placing custom mantel above built-in rebox,
you must meet the minimum allowable clearance
between mantel shelf and top of rebox opening
shown in Figure 7. These are the minimum allowable
mantel clearances for a safe installation. Use larger
clearances wherever possible to minimize the heat-
ing of objects and materials placed on the mantel.
CAUTION: Do not allow the
-
-
Follow all minimum clearances
NOTICE: If your installation does
not meet the minimum clearances
shown, you must do one of the
-
• remove the mantel
BUILT-IN FIREBOX INSTALLATION
Built-in installation of this rebox involves install-
ing rebox into a framed-in enclosure. This makes
the front of rebox ush with wall. Optional brass
trim accessories are available (see Accessories,
page 31). The brass trim will extend past sides
of rebox approximately 1/2". This will cover
the rough edges of the wall opening. If installing
a mantel above the rebox, you must follow the
clearances shown in Figure 6, page 10. Follow
the instructions below to install the rebox in
this manner.
Figure 7 - Minimum Mantel Clearances for Built-In Installation
Supplied
Firebox Hood
Must Be Used
at All Times
Wire-mesh
Screen
Firebox
Noncombustible
Material May
Project Off this
Surface above
the Firebox Hood
Mantel Shelf
Note: Any portion of the
mantel shelf must NOT
extend beyond this profile.
12" 16" 20"
1
1
/
2
"
6
3
/
4
"
12"
Note: All vertical
measurements are
from top of fireplace
hood opening to
bottom of mantel shelf.
These minimum
clearances replace any
other recommended
clearances supplied
with your ANSI Z21.11.2
approved gas logs.
Wall board or facing
material (above
firebox) may be of
combustible material,
including decorative
mantel ornaments or
other similar projec-
tions off of the facing
material.
Framing
Material