Filter
Top Products
www.desatech.com
119305-01A
17
INSTALLATION
Continued
INSTALLING LOGS
-
CAUTION: Do not remove
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place bottom log in center of the base assem-
bly as shown in Figure 21.
2. Rest rear log in back corner sections of base
assembly as shown in Figure 21. Make sure
log is completely vertical and not leaning in
toward burner where the ame will touch the
log.
3. Position front right log against right side of
grate prongs (see Figure 21).
4. Position front left log against left side of grate
prongs (see Figure 21).
5. Place middle right log over front right and bot-
tom logs as shown in Figure 22. Be sure hole
in middle right log seats over pin in bottom
log.
6. Place middle left log over front left and bot-
tom logs as show in Figure 22. Be sure hole
in middle left log seats over pin in front left
log.
-
Figure 21 - Installing Bottom Logs
4. Check all joints from equipment shutoff valve
to gas control valve (see Figures 19 or 20, page
16). Apply noncorrosive leak detection uid
to all joints. Bubbles forming show a leak.
5. Correct all leaks at once.
6. Light replace (see Operating Fireplace, page
19. Check all other internal joints for leaks.
7. Turn off replace (see To Turn Off Gas to
Appliance, pages 20 or 22, depending on your
model).
Figure 22 - Installing Top Logs
Rear Log
Grate
Prongs
Bottom
Log
Base Assembly
Front Right
Log
Front Left Log
Middle Right Log
Middle Left Log
Bottom
Log
Pin on Front
Left Log