Filter
Top Products
www.desatech.com
108796-01L16
INSTALLATION
Continued
COMBUSTION AIR KIT MODEL AK4
(OPTIONAL)
The outside air kit may be installed on the left side
of the replace only. The vent can be installed
through any outside wall a minimum of three feet
below replace termination cap. The handle to
operate the damper door for the outside air inlet
will be located inside the left “screen pocket” of
the rebox (see Figure 31). Pull the handle to open
or push to close.
CAUTION: Air inlet ducts are
nottoterminateinatticspace.
Figure 31 - Air Kit Handle Location
Air Kit
Handle
Screen
Pocket
APPLIANCE ENCLOSURE
Before nishing the enclosure around the appli-
ance, inspect all joints around the outer surround.
Any gaps between the nailing anges and the
framing should be sealed with noncombustible
insulation or caulking.
If the appliance is mounted on a raised platform,
it must be a continuous surface and not on blocks
without a solid surface. This will prevent the entry
of cold air by means of conduction through the
total bottom of the appliance (see Figure 32).
Side
Framing
Side
Framing
Caulk Here
Pack Insulation
Figure 32 - Sealing Between Appliance
and Framing
INSTALLING OPTIONAL GLASS
DOOR ACCESSORY
CAUTION: Use only glass
doorscertiedforusewiththis
appliance.
Note: Glass door may be heavy for some individu-
als. If this is the case, please request help from
someone else.
The M36E, VM36E, M42E and VM42E B-vent
replaces are approved for use with optional bi-
fold glass doors (see Accessories, page 29). The
glass panels may be ordered and installed anytime
after the replace installation is complete.
Follow these steps to install left and right panels:
1. With the handle at the bottom, completely fold
the panel on its hinges.
2. With the handle facing the center of the rebox
opening, insert the lower pivot pin on the glass
door panel into the hole in pivot plate on the
bottom edge of the replace opening (see
Figure 33).
3. Keeping the folded door tilted, slide the upper
two pins into the guide track found under the
upper facial edge of the rebox opening.
4. Tilt the glass assembly fully vertical until the
outer pivot pin snaps into the mounting hole
in the upper spring clip (see Figure 33).
5. Once the top and bottom pins are secured,
unfold the door into the closed position.
Figure 33 - Installing Optional Glass
Door
Spring Clip
Insert Pin Into
Spring Clip
Insert Bottom Pivot Pin Into
Pivot Plate and Swing Door
Into Vertical Position
Pivot Plate
Slide Top
Pin Into
Door Track