Filter
Top Products
www.desatech.com
108796-01L 11
CHECKING FOR PROPER VENTING
After completing and checking the electrical,
gas and vent connections, follow the lighting
instructions and allow the main burner to run for
approximately 5 minutes. Hold a lighted match or
cigarette near the top edge of the replace opening
and play it along the entire length of the opening
(see Figure 12). Proper venting should tend to draw
the ame or smoke into the appliance. Improper
venting or escaping of spillage of burned gas, is
indicated when the match ickers or goes out.
Smoke from a cigarette will also tend to disperse
away from the appliance.
If the appliance is found to be improperly venting,
shut it off and notify your installer or a qualied
service agency to inspect the venting system.
NOTICE: This appliance is
equipped with a vent safety shutoff
switch which will shut down the
appliance in the case of a venting
problem.Donotbypassthevent
safety switch. If the appliance
should shut down, contact a quali-
edinstaller,serviceagencyor
your gas supplier to have the vent
inspectedbeforeoperating.
VENTING INSTALLATION
Continued
Check this area along
the entire top edge of
the replace opening.
Smoke or ame should
be drawn into the
appliance opening.
Figure 12 - Checking for Spillage
INSTALLATION
WALL SWITCH INSTALLATION
The installation of a wall switch allows you to
activate the gas control valve and turn the replace
on and off. The wall switch is to be connected to
the incoming 120 volt regular household wiring
that supplies the electricity to the replace. Refer
to wiring diagram in this manual on page 18.
OPTIONAL REMOTE CONTROL
INSTALLATION(ModelWRC)
Note: If using optional wireless hand-held remote
control, the wall switch must be in the ON position
to be operational. The remote control then becomes
the switching mechanism for replace operation.
1. Remove the front refractory access panel by
lifting up and angling out of the rebox open-
ing (see Figure 13).
2. The WRC model receiver does not require a
battery. The receiver can be installed by rst
plugging the short extension cord into the
replace receptacle. Then plug the receiver
unit into the extension cord. Finally plug the
ignition module plug into the receiver unit (see
Figure 14).
Figure 13 - Removing Front Refractory
Access Panel
Figure 14 - Installing the WRC Remote
Receiver
Fireplace
Receptacle
Remote
Control
Receiver
Extension Cord
Ignition
Module
Plug