Filter
Top Products
114745-01
For more information, visit www.desatech.com
16
NOTICE: You must light the pilot before using the remote control unit.
See Lighting Instructions
on page 14.
GHRCTB Series Operation:
2a. Press the AUTO/ON/OFF button on the hand-held remote control
(see Figure 21). The lights to the left of the button will show AUTO,
ON, or OFF.
• In the ON mode, the burners will ignite. The heater is in manual
mode when ON is lit.
• In the AUTO mode, the thermostat in the hand-held remote
unit controls the room temperature. To increase the room tem
-
perature, press the top arrow of the TEMP button. To lower the
room temperature, press the bottom arrow of the TEMP button.
At higher settings the heater will run longer.
IMPORTANT: This remote control has been specially engineered
to take an air temperature sample every 5.5 minutes in the auto
mode. It will not respond immediately to the temperature setting
being turned up or down.
IMPORTANT: The hand-held remote control unit must be near the
heater. Do not keep the hand-held remote control unit too close to
the heater. The thermostat on the hand-held remote control unit
will heat up too quickly and turn the heater off.
3. To turn the burner off, press the AUTO/ON/OFF button until OFF
lights. The pilot will remain lit.
OPERATING HEATER (REMOTE-READY MODELS)
Remote Control Operation (Cont.)
Figure 20 - Setting the Selector switch, Control Knob, and Flame
Adjustment Knob for Remote Operation
Figure 21 - Thermostat Hand-Held Remote Control Unit Selections
(GHRCTB Only)
Increases Room
Temperature in
AUTO Mode
Decreases Room
Temperature in
AUTO Mode
Turns Burners On
or Off and Allows
You to Choose the
Auto Setting
Shows
Temperature
Setting
The Log Heater will
Automatically Cycle
between Pilot and the
Heat Setting that has
been Selected
OPERATING HEATER
Continued
IMPORTANT: Do not leave the selector switch in the REMOTE or
ON position when the pilot is not lit. This will drain the battery.
2. Press the ON/OFF button to turn the burners on and off. When
turning burners off, the pilot will remain lit.
IMPORTANT: Be sure to press the ON/OFF buttons on the hand-
held remote control unit for up to 3 seconds to assure proper
operation.
Note: All additional remote control accessories must be purchased
separately (see Accessories, page 27). Follow instructions included
with the remote control.
Thermostat Control Operation
(Optional GHRCTB Series Only) The thermostat control setting on the
remote control unit can be set to any comfort level between WARMER
and COOLER. The burners will turn on and off automatically to main-
tain the comfort level you select. The ideal comfort setting will vary
by household depending upon the amount of space to be heated, the
output of the central heating system, etc.
For wall thermostat operation, follow instruction supplied with thermo-
stat accessory GWMT1. For wall switch operation follow instructions
supplied with GWMS2.
IMPORTANT: To turn the pilot off, manually turn the control knob
on the heater to the OFF position.
114745-01