Filter
Top Products
114745-01
For more information, visit www.desatech.com
15
15
OPERATING HEATER (REMOTE-READY MODELS)
Lighting Instructions (Cont.)
To Turn Off Gas To Appliance
Manual Lighting Procedure
Remote Control Operation
OPERATING HEATER
Continued
Figure 18 - Control Knob and Ignitor Button Location,
Remote Ready Controlled
pressing ignitor button until pilot lights.
Note: If pilot does not stay lit, contact a qualified service person or gas
supplier for repairs. Until repairs are made, light pilot with match. To
light pilot with match, see Manual Lighting Procedure, column 2.
8. Keep control knob pressed in for 30 seconds after lighting pilot. After
30 seconds, release control knob.
• If control knob does not pop out when released, contact a qualified
service person or gas supplier for repairs.
Note: If pilot goes out, repeat steps 4 through 8, pages 14 & 15.
9. Slightly push in and turn control knob counterclockwise
to the
ON position.
10. Wait one minute and switch selector switch to the ON position to light
burners. Note: AUTO is only functional when using GWMT1 or GWMS2
optional accessories.
11. Set flame adjustment knob to any level between HI and LO.
CAUTION: Do not try to adjust heating levels by using the
equipment shutoff valve.
WARNING: Make sure the selector switch is in the OFF position
when you are away from home for long periods of time. Heater will
come on automatically with selector switch in the ON position.
Shutting Off Heater
1. Turn control knob clockwise to the OFF position.
2a. Set selector switch in the OFF position.
2b. If Using Optional Hand-Held Remote: Set selector switch in the OFF
position to prevent draining battery.
Shutting Off Burner Only (pilot stays lit)
You may shut off the burners and keep the pilot lit by doing one of the fol-
lowing:
1. Turn control knob clockwise
to the PILOT position.
2. Use remote control manual OFF button.
3. Set selector switch in the OFF position.
Figure 19 - Pilot (Propane/LP)
Ignitor
Electrode
Pilot
Burner
Pilot (Natural)
Ignitor
Electrode
Pilot Burner
TO TURN OFF GAS TO APPLIANCE
MANUAL LIGHTING PROCEDURE
1. Follow steps 1 through 6 under Lighting Instructions, page 14.
2. Depress control knob and light pilot with match.
3. Keep control knob pressed in for 30 seconds after lighting pilot. After 30
seconds, release control knob. Now follow steps 9 through 11, Lighting
Instructions, column 1.
Remote Control Operation
GHRCB Series Operation:
1. After lighting, let pilot flame burn for about one minute. Turn control knob
to ON position. Adjust flame adjustment knob anywhere between HI
and LO. Slide the selector switch to the REMOTE position. Note: The
burners may light if hand-held remote ON button was on when selector
switch was last turned off. You can now turn the burners on and off with
the hand-held remote control unit.
REMOTE CONTROL OPERATION
114745-01