Filter
Top Products
13
104637
OWNER’S MANUAL
O
F
F
P
I
L
O
T
O
N
H
I
L
O
Figure 24 - Installing One Piece Log Set
Chassis
"U"-shaped
Cutout in
Chassis
One Piece
Log Set
One Piece Log Set
Burner Ports
Figure 25 - Installing One Piece Log Set (Top View)
Figure 26 - Installing Fireplace Front Window Assembly
WARNING: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to High, check to see if
flame contact any log. If so, repo-
sition logs according to the log
installation instructions in this
manual. Flames contacting logs
will create soot.
It is very important to install the logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place one-piece log set on grate to fit
as illustrated in Figure 25. Make sure
middle section at bottom of log set is
seated into "U"-shaped cutout in cen-
ter of chassis (see Figure 24).
IMPORTANT:
Make sure log does not
cover any burner ports.
2. Install front window assembly to front
of fireplace by slipping bottom window
tabs into rectangular notches on fire-
place front (see Figure 26). Then insert
and tighten two screws through the top
corners of the window assembly and
fireplace front.
WARNING: You must operate
this fireplace with the front win-
dow assembly in place. Make sure
front window assembly is in place
before running fireplace.
Burner
Middle
Section at
Bottom of
Log Set
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
INSTALLING LOGS
INSTALLATION
Continued
CAUTION: Do not remove the
warning and instruction labels
attached to the heater base as-
sembly. These markings contain
important warranty information.
Continued
Screw
Front Window
Assembly
Front Window
Assembly
Window Tabs
Notches