Filter
Top Products
www.desatech.com
113084-01A 27
ACCESSORIES
Purchase these heater accessories from your local
dealer. If they can not supply these accessories,
call DESA Heating Products at 1-866-672-6040
for referral information. You can also write to the
address listed on the back page of this manual.
EQUIPMENT SHUTOFF VALVE
GA5010
For all models. Equipment shutoff valve with 1/8"
NPT tap. Fits 1/2" NPT pipe.
RECEIVER AND HAND-HELD
THERMOSTAT REMOTE CONTROL
KIT - GHRCTB
For remote-ready models. Allows the gas log
heater to be operated in a manually or thermostati-
cally controlled mode. You can turn the gas log
heater on and off without ever leaving the com-
fort of your easy chair.
RECEIVER AND HAND-HELD
REMOTE CONTROL KIT - GHRCB
For remote-ready models. Allows the gas log
heater to be turned on and off by using a hand-
held remote control.
WALL-MOUNT THERMOSTAT
SWITCH GWMT1
(Not Shown)
For remote-ready models. The desired comfort
setting can be selected on the wall thermostat and
the log heater will automatically cycle from pilot
to the heat setting selected.
WALL-MOUNT ON/OFF SWITCH -
GWMS2
(Not Shown)
For remote-ready models. Allows the gas log
heater to be turned on and off with a wall switch.
CLEANING KIT - GCK
(Not Shown)
For all models. Your vent-free gas appliance re-
quires regular cleaning and maintenance to pre-
vent performance problems. This kit gives you the
tools and instructions to make it easy to clean all
critical areas of your appliance.
INFORMATION VIDEO - 108917-01
For all models. A care and maintenance video is
available by calling 1-866-672-6040. You may also
email your request to
productsupport@desaint.com.
FIRE CRACKLE - CF6-A
(Not Shown)
For all models. Creates the sound of a real burn-
ing fire.
STOVE HEARTH BASE - GC10SP
(Not Shown)
For all models. Hearth base stained oak finish.
Required when stove is placed on carpet. Dimen-
sions 4" x 35
3
/4" x 30
1
/2" (H x W x D).
STOVE CONVERSION KIT - 113051-01
For models using SVYD18NR/PR vent-free
stove inserts. This kit supplies stove back panel,
stove dropped bottom and needed hardware to
mount the vent-free heater into the stove.