Filter
Top Products
www.desatech.com
122527-01B 5
ASSEMBLY
Figure 4 - Cabinet Base Assembly
Cabinet
Base
Tank
Door
Base
Ignitor
Retainer
Ring
Ignitor
Cap
BASE ASSEMBLY
1. Connect 2 base parts using 5 screws (C),
5 washers (D) and 5 nuts (E) as shown in
Figure 3.
2. Turn base upside down. Attach 2 wheels,
2 hex bolts (A) and 2 nuts (B) as shown
in Figure 3. Do not overtighten.
3. Being careful not to scratch paint, lay
cabinet base onto back side (use foam
packaging block to support rear top of
cabinet base). Align holes in bottom
edges of cabinet base with holes in base
as shown in Figure 4. Attach with 1 screw
F
H
B
C
D
E
G
A
Figure 3 - Attaching Wheels to Base
Base
Wheel
Nut (B)
Hex Bolt (A)
(C), 1 washer (D) and 1 nut (E) for each of
the 9 holes (see Figure 4). Set assembly
upright.
4. Install chain retainers (“S” hooks) to up-
per edges of cabinet base as shown in
Figure 4.
5. Install electronic ignitor through cabinet
wall as shown in Figure 4. Hand tighten.
6. Attach tank door to cabinet with 4 screws
(F) and 4 nuts (G) as shown in Figure 4.
Set entire assembly aside.
Chain
Retainer
Nut (E)
Washer (D)
Screw (C)
Estimated assembly time: 45 minutes
Tools required:
• #2 Phillips screwdriver
• 1/2", 5/16" and 7/32" Open end wrenches
Hardware packet provided with heater may
contain more parts than needed for heater
assembly.
Hardware packet contains the following items
shown on pages 10 through 13:
Electronic Ignitor (1), Ignitor Wire (1), Ground
Wire (1), Valve Knob (1), Propane Tank Reten-
tion Chain (1), Retention Hook (2), D Batteries (2)
and AA Battery (1).
Parts are referenced by designated letter
throughout assembly instructions. Hardware
packet contains the following (quantity used
in parenthesis):
Description Part No.
A 2
1
/
4
" Hex Bolt (2) HC4-18C
B 12 mm Hex Nut (2) NPC-5C
C 5/8" Screw (14) 119619-03
D 5 mm Washer (14) 119600-02
E 5/16" Hex Nut (14) NPC-3C
F 3/8" Screw (20) 119619-06
G 7/32" Hex Nut (20) NPC-1C
H 3/8" Self tapping screw (34) 119620-02
Screw (F)
Nut (G)
Screw
(C)
Washer
(D)
Nut (E)