Filter
Top Products
www.desatech.com
113084-01E 11
INSTALLATION
Continued
CAUTION: Do not remove the
data plates attached to the heater
base assembly. The data plates
contain important warranty and
safety information.
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specically approved with
this heater may result in property
damage or personal injury.
INSTALLING GAS LOG INTO STOVE
1. Remove log from carton.
2. Remove all protective packaging applied to
log for shipment.
3.
Check log for any shipping damage. If damaged
(pieces larger than the size of a dime), promptly
inform dealer where you bought heater.
4. Set one-piece log on heater base as shown in
Figure 12. Make sure middle section at bot-
tom of log is seated into “U” shaped cutout
in center of heater base. Log will t securely
on base. IMPORTANT: Make sure log does
not cover any burner ports and does not touch
the stove cavity (see Figure 13).
5. Fasten back panel to stove with four (4)
M6 x 1 bolts and washers.
6. Place freestanding stove in desired position
in room. Be sure to maintain clearances to
combustibles as outlined on page 8.
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no ame
comes in contact with any log.
With the heater set to HI, check
to see if ames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
Burner Porting Areas (double
slotted rectangular openings)
Figure 13 - Top View of One-Piece Log
Set on Gas Log Heater
Safety Pilot Location
One-Piece
Log Set
One-Piece
Log Set
“U” Shaped
Cutout in Chassis
Burner
Middle
Section at
Bottom of
Log Set
Figure 12 - Installing One-Piece Stove
Log Set
Heater Base
CONNECTING TO GAS SUPPLY
WARNING: This appliance
requires a 1/2" NPT (National
Pipe Thread) inlet connection to
the pressure regulator.
WARNING: A qualied service
person must connect heater to gas
supply. Follow all local codes.
CAUTION: Never connect
propane/LP heater directly to the
propane/LP supply. This heater
requires an external regulator
(not supplied). Install the exter-
nal regulator between the heater
and propane/LP supply.