Filter
Top Products
5
103252
ASSEMBLY
Front
Handle
Wheel
Support
Frame
Wheel
Hot Air
Outlet
Fuel
Tank
Flange
Cap Nut
Axle
Air
Inlet
Screw
Nut
Figure 2 - Wheel and Handle Assembly
Extended
Hub
This model is furnished with wheels and a front handle. Wheels, handle, and the
mounting hardware are found in the shipping carton.
Tools Needed
• Medium Phillips Screwdriver
• 3/8" Open or Adjustable Wrench
• Hammer
1. Slide axle through wheel support frame. Install wheels on axle.
IMPORTANT:
When installing wheels, point extended hub of wheels toward
wheel support frame (see Figure 2).
2. Place cap nuts on axle ends. Gently tap with hammer to secure.
3. Place heater on wheel support frame. Make sure air inlet end (rear) of heater is
over wheels. Line up holes on fuel tank flange with holes on wheel support
frame.
4. Place front handle on top of fuel tank flange. Insert screws through handle,
fuel tank flange, and wheel support frame. Attach nut finger tight after each
screw is inserted.
5. After all screws are inserted, tighten nuts firmly.