Filter
Top Products
www.desatech.com
119526-01A 21
Setting Room Temperature
Press the up or down key until the small
triangle is to the left of the thermometer icon
(see Figure 34). Press the left or right key to
set the desired room temperature.
Setting Timer (Sleep Function)
Press the up or down key until the small triangle
is to the left of the clock icon (see Figure 34).
Press the left or right key to set the desired
sleep time. Maximum sleep time is 90 minutes,
in 15 minute increments. When desired time is
set, press the up or down key to start the timer.
When the desired time has elapsed, the appli-
ance will automatically switch off.
Child Safety Lock-Out
To lock the remote control keys, press the
On/Off key then immediately press the up key
(see Figure 38). The lock-out function is active
when the lock icon is lit. Repeat key sequence
to unlock keys.
Low Battery Detection and Backup
A battery icon will be displayed on the LCD
display when batteries are low in the remote
control (see Figure 34).
When the receiver detects a low battery
condition;
• Three acoustic “beeps” are generated from
the receiver
• Appliance is turned off and will go to the
maximum ame height
• Execution of commands is inhibited until
batteries are replaced
When batteries are low, it is not possible to
turn on the appliance with the remote control.
Appliance can be turned on or off manually
by setting the backup switch of the receiver to
MAN position (see Figure 31, page 20). Remote
control and receiver will restart normal opera-
tion after batteries are replaced. See Installing
Batteries for Remote Receiver and Hand Held
Remote Control, page 19.
Timeout
If appliance is turned on and no command is
sent to the receiver for 24 hours, appliance will
automatically shut down. Commands sent after
shutdown will be executed normally.
OPERATING HEATER
Continued
HAND-HELD
REMOTE OPERATION
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions, page 19.
When the appliance and the remote control
are switched off, the house icon with the room
temperature will be displayed. When the re-
mote control is turned on, other icons will be
visible and the main burner of the appliance
will turn on.
1. Turn control knob clockwise to the
ON position (see Figure 31, page 20).
2. Press the ON button on remote control
(see Figure 34). Wait 5 seconds to send a
command to appliance.
Note: An acoustic signal will be heard that
conrms the reception of the command sent
from the remote control.
Setting Flame Height
Press the up or down key until the small triangle
is to the left of large ame icon at the top of
LCD display (see Figure 34). Press the left or
right key to set the desired ame height. Six
ame levels are available from 1 (minimum)
to 6 (maximum).
Left and
Right Keys
Increase and
Decrease
Set Points
On/Off
Button
Flame Height
Indicator
Thermometer
Icon
Clock Icon
Figure 34 - Remote Control
Small Triangle
Icon (Function
Indicator)
LCD Display
Room
Temperature
Display
Sleep Timer
Display
Lock-Out
Indicator
Low Battery
Indicator
Up and Down Keys Moves
Placement from Top to
Bottom on LCD Display