Filter
Top Products
www.desatech.com
113195-01C 17
INSTALLATION
Continued
Figure 24 - Installing Log Set (Top View)
Figure 25 - Installing Fireplace Insert
Screen
Notches
Screws for
Mounting
Screen
Burner Ports
Figure 23 - Installing Log Set
O
F
F
P
I
L
O
T
O
N
H
I
L
O
Chassis
Log Set
Crossover
Log #3
Burner
Front
Log #2
Back
Log #1
Grate
Prongs
INSTALLING LOGS
CAUTION: Do not remove the
warning and instruction labels at-
tached to the heater base assembly.
These markings contain important
warranty and safety information.
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specically approved with
this heater may result in property
damage or personal injury.
WARNING: After installa-
tion and periodically thereafter,
check to ensure that no ame
comes in contact with any log.
With the heater set to HI, check
to see if ames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
It is very important to install the logs exactly as
instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place back log #1 on grate to t as illustrated
in Figure 23. Make sure middle section at
bottom of log set is seated into “U”-shaped
cutout in center of chassis (see Figure 23).
IMPORTANT: Make sure log does not cover
any burner ports (see Figure 24).
2. Place front log #2 against front grate prongs
as shown in Figure 23.
3. Place crossover log #3 on top of front and back
logs as shown in Figure 23.
4. Place lava rock around base of heater if desired.
WARNING: You must oper-
ate this replace insert with the
replace insert screen in place.
Make sure replace insert screen
is in place before running re-
place insert.