Filter
Top Products
www.desatech.com
116239-01E 27
8. Install rear brick panel rst. Rest bottom edge
of panel on back edge of burner assembly (see
Figure 44).
9. Install left side brick panel by sliding it be-
tween the burner assembly and the side of the
rebox (see Figure 44).
10. Install the right brick panel using the same
method described in step 6 for left brick
panel.
11. Replace deector shield using screws removed
in step 7.
12. Using screws removed in step 6, replace
plenum and attach to burner.
13. Carefully replace the ember pod and log set.
14. Use screws removed in step 4 to replace andiron
assembly.
15. Install lava rock and glowing embers. See
Installing Lava Rock and Glowing Embers,
page 26.
16. Close glass door and lock latches on top and
bottom of door and replace screen. See Removing
Glass Door, steps 5 and 6, page 26.
17. Replace top and bottom louvers.
FIREPLACE
INSTALLATION
Continued
Figure 44 - Installing Rear Brick Panel
Rear Brick
Panel
Left Side Brick
Panel
OPERATING FIREPLACE
FOR YOUR SAFETY
WARNING: If you do not fol-
low these instructions exactly,
-
A. This appliance has a pilot which must be
lighted by hand. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next
to the oor because some gas is heavier than
air and will settle on the oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not
use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
C. Use only your hand to push in or turn the
gas control knob. Never use tools. If the knob
will not push in or turn by hand, don't try to
repair it, call a qualied service technician.
Force or attempted repair may result in a
re or explosion.
D. Do not use this appliance if any part has
been under water. Immediately call a
qualied service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water.
LIGHTING
1. STOP! Read the safety information
above.
2. Open lower louver panel.
3. Turn off all electric power to the replace.
4. Push in gas control knob slightly and turn
clockwise to “OFF”.
5. Wait ve (5) minutes to clear out any gas.
Then smell for gas, including near the oor.
If you smell gas, STOP! Follow “B” in the
safety information above. If you don't smell
gas, go to the next step.
6. The pilot is located by the main burner and
should not require accessing for lighting.