Filter
Top Products
www.desatech.com 111160-01C
30
4. The mounting clip must be a minimum of 3"
from bottom of fireplace to prevent crimping
of capillary. Once you have decided on a lo-
cation, clean the area thoroughly. Remove the
paper backing from the adhesive on back of
mounting clip. Press the clip into the new lo-
cation so that the thermostat sensing bulb will
be positioned vertically with the capillary at
the bottom (see Figure 49). Slide the thermo-
stat sensing bulb into the clip.
IMPORTANT:
Do not crimp capillary.
Figure 49 - Positioning the Thermostat
Sensing Bulb in the Vertical Position
with the Capillary at the Bottom
Capillary
Thermostat
Sensing Bulb
Do Not Crimp
Capillary
Adhesive-backed
Mounting Clip
OPTIONAL POSITIONING
OF THERMOSTAT
SENSING BULB
Continued
REPLACEMENT PARTS
Note:
Use only original replacement parts. This
will protect your warranty coverage for parts re-
placed under warranty.
PARTS UNDER WARRANTY
Contact authorized dealers of this product. If they
can’t supply original replacement part(s), contact your
nearest Parts Central (see page 42) or call DESA
Heating Products’ Technical Service Department at
1-866-672-6040 for referral information.
When calling DESA Heating Products, have ready
• your name
• your address
• model and serial numbers of your heater
• how heater was malfunctioning
• type of gas used (propane/LP or natural gas)
• purchase date
Usually, we will ask you to return the part to
the factory.
PARTS NOT UNDER WARRANTY
Contact authorized dealers of this product. If they can’t
supply original replacement part(s), contact your near-
est Parts Central (see page 42) or call DESA Heating
Products at 1-866-672-6040 for referral information.
When calling DESA Heating Products, have ready
• model number of your heater
• the replacement part number